IAPMO RESEARCH AND TESTING, INC.

5001 E. Philadelphia Street, Ontario, CA 91761-2816 • (909) 472-4100 • Fax (909) 472-4244 • www.iapmort.org





CERTIFICATE OF LISTING

IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in the characteristics below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product acceptance by Authorities Having Jurisdiction.


 

Effective Date:
October 2013        
Void After: October 2014
     
Product: Bathtubs (Plastic) 
File No. 7193
     
Issued To: HANSGROHE SE
AUESTRASSE 5-9
SCHILTACH,   D-77761
GERMANY
     
Identification:
Manufacturer's name or trademark, or both, and the date of manufacture shall be permanently and legibly marked on the unit. The product shall also bear the cUPC® certification mark.  The manufacturer's identity and cUPC® mark shall be readily visible after installation.
     
Characteristics:
One piece plastic bathtubs are manufactured with or without walls and with right or left hand outlets. Bathtubs intended for installation against a wall shall incorporate and integral, factory applied or field applied nailing flange in accordance with IAPMO/ANSI Z124.1.2-2005. Bathtubs without factory applied nailing flanges are listed as drop-in units only, and are not to be installed against the wall. To be installed in accordance with the manufacturer's instructions affixed to the unit and the requirements of the latest edition of the Uniform Plumbing Code. Whirlpool piping is not included in this listing. Piping, if installed, must carry a separate IAPMO listing.

TILE FLANGE KITS: The use of a listed tile flange kit allows installation against the wall.

Products listed on this certificate have been tested by an IAPMO R&T recognized laboratory. This recognition has been granted based upon the laboratory's compliance to the applicable requirements of ISO/IEC 17025.
     
Products are in compliance with the following code(s):
 
Uniform Plumbing Code (UPC®)
National Plumbing Code of Canada
International Plumbing Code (IPC®)
 
Products are in compliance with the following standard(s):
 
CSA B45.5-11/IAPMO Z124-2011

 

 

models_0007193

MODELS:

 

 

Axor

 

Model No.     Description

11440000      Urquiola, 1,820 x 795 x 870 (mm)

18950000      Massaud, 1,891 x 1,536 x 620 (mm)

19955000      Bouroullec, 1,710 x 781 x 512 (mm)