IAPMO RESEARCH AND TESTING, INC.
5001 E. Philadelphia Street, Ontario, CA 91761-2816 • (909) 472-4100 • Fax (909) 472-4244 • www.iapmo.org
CERTIFICATE OF LISTING
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in the characteristics below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product acceptance by Authorities Having Jurisdiction.
| Effective Date : | July 2009 | Void
After:
July 2010 |
| Product: | Suction Fittings | File
No. SP-1188 |
| Issued To : | G/G INDUSTRIES, A DIVISION OF BALBOA WATER GROUP 1382 Bell Ave TUSTIN, CA 92780 |
|
| IDENTIFICATION: | Fittings shall be permanently marked as follows in a manner so as to be visible after installation in the following sequence (1) The statement "For Single or Multiple Drain Use Only", "For Single Drain Use", or "For Multiple Drain Use only"; (2) Maximum flow rate; (3) Type of fitting; (4) Life of the fitting in years; (5) Installation position; (6) Manufacturers name or registered trademark; (7) Model designation, and the USPC® certification mark. | |
| CHARACTERISTICS: | The assembly is comprised of safety cover (brass, stainless steel, or plastic) drain ring and security screws. The cover must require the use of a tool to remove it. May or may not be self-draining. For use in swimming pools, spas, whirlpool bath tubs and hot tubs. To be installed in accordance with the manufacturer's instructions and the latest edition of the USPC®. Products comply with the applicable sections of the latest edition of the Uniform Swimming Pool, Spa and Hot Tub Code® and the International Plumbing Code®. Manufactured in compliance with ASME A112.19.8-2007 and ASME A112.19.8a-2008. Products listed on this certificate have been tested by an IAPMO R&T recognized laboratory. This recognition has been granted based upon the laboratory’s compliance to the applicable requirements of ISO/IEC 17025. |
|
MODELS: Model No. Description 30173U Suction Fitting For Spas ( Wall: 124 gpm) 30199U Suction Fitting For Spas ( Wall: 100 gpm) 30231U Suction Fitting For Spas ( Wall: 212 gpm) |
||
| ADDITIONAL COMPANIES: | ||
| ADDITIONAL COMPANY INFO: | ||
